CSA ANSI HGV 3.1-2015 (R2019)

CSA ANSI HGV 3.1-2015 (R2019)

Click here to purchase
Scope

1.1 This Standard establishes requirements for newly produced compressed hydrogen gas fuel system components, intended for use on hydrogen gas powered vehicles as listed below:
a) check valves;
b) manual valves;
c) manual container valves;
d) automatic valves;
e) gas injectors;
f) pressure indicators;
g) pressure regulator;
h) pressure relief valves;
i) pressure relief devices;
j) excess flow valves;
k) gas-tight housing and leakage capture lines and passages;
l) rigid fuel lines;
m) flexible fuel lines;
n) filter housing;
o) fittings; and
p) discharge line closures.

Note: It is recognized that other components not specifically covered herein can be examined to meet the criteria of HGV 3.1 and tested according to the appropriate functional needs.

1.2 This Standard applies to devices that have a service pressure of either 25MPa, 35MPa, 50MPa, or 70MPa hereinafter referred to in this Standard as the following:
a) “H25” – 25 MPa;
b) “H35” – 35 MPa;
c) “H50” – 50 MPa;
d) “H70” – 70 MPa.

This Standard also applies to components downstream of the first stage of pressure reduction with a maximum operating pressure designated by the manufacturer in kPa (psi).

1.3 This Standard addresses the pressure containment, performance, and safety characteristics of components listed Clause 1.1.

1.4 This Standard does not apply to the following:
a) hydrogen gas fuel system components incorporated during the manufacture of motor vehicles originally manufactured in compliance with the Federal Motor Vehicle Safety Standards (FMVSS) for Compressed Hydrogen Gas Fueled Vehicles and the Canadian Motor Vehicle Safety Standard (CMVSS);
b) fuel containers;
c) stationary gas engines;
d) container mounting hardware;
e) electronic fuel management;
f) refueling receptacles; or
g) three-way valves.

Product Details

Edition:
1st
Published:
02/01/2015
ISBN(s):
9781771396424
Number of Pages:
77
File Size:
1 file , 1 MB
Product Code(s):
2423210, 2423210, 2423210

You may also like

CSA C22.2 NO. 80601-2-13:23

CSA C22.2 NO. 80601-2-13:23

Medical electrical equipment — Part 2-13: Particular requirements for basic safety and essential performance of an anaesthetic workstation (Adopted ISO...

CSA O125:23

CSA O125:23

Mechanically laminated timber — Production and qualification specificationsstandard by CSA Group, 04/27/2023

CSA Z21.89:23/CSA 1.18:23

CSA Z21.89:23/CSA 1.18:23

Outdoor cooking specialty gas appliancesstandard by CSA Group, 06/24/2023

CSA C865.1:23

CSA C865.1:23

Light-emitting diode drivers — Methods of measurement (Binational standard with NEMA ANSI C82.16-2023)standard by CSA Group, 06/29/2023

Back to Top